Edit

Digital Control

In brief, the Scalextric protocol leverages a square-wave 12v p-p high current signal driven onto the track. The signal is balanced, such that each 'side' of the lane is driven in opposite voltage, allowing the car to rectify this waveform and recover (with some small losses) a DC voltage for the motor.

Inside the car is mounted a small decoder which recovers the control signal, interprets in, and drives the power back to the motor. Motor speed and braking is controlled via the decoder - unlike analog where the speed is directly controlled within the hand controller.

Full details on the control signal provided by the controller are discussed on Scalextric Digital Control page. This also provides a link to circuit diagram and PIC18 programming code to create your own 6 car power base.

Edit

Car Detection

Beneath the car is mounted a small Infra-Red LED which constantly pulses the car's ID downwards onto the track. Detectors mounted under the slot pick up the signal, and can decode which car is passing over them. The same signal carries detail on whether a car should change lanes or not, and when detected by a special lane-change track-piece, a physical 'flipper' will cause the car to move from one lane to another.

The car detection is also used for lap counting, as simple car-pass detection methods from analogue racing cannot be used as more than one car can be driving in the same lane.

Full details on the decoding of a car's ID are provided on the Scalextric Car Decoding page. This includes circuit diagrams and PIC12 programming code to decode and deliver the car ID.

For those who wish to review the detector circuit, and the micro-controller code, move straight to SSD Decoder page.

Edit

Powerbase 6 Repair

The six-car powerbase (PB6) is somewhat underdesigned, with an output driver stage which does not efficiently power the final transistors. This caused those driver transisitors to become overheated under heavy load, and then prone to failure should a short-circuit occur.

Repairing a blown powerbase when the one of more output drivers have failed, is not a tricky task. However replacing the MOSFETs with the same part and returning to the same environment can only mean another failure. This repair up-rates the MOSFETs with common components, extending the headroom for the powerbase.

See the PB6 repair page for step-by-step instructions to repair a blown PB6 (v1.5 design)

Edit

Pro Upgrades - PB-Pro and PitPro

A group of enthusiasts have invested significant time and energy to up-rate the Scalextric core components with more power and better facilities. The Pro range of tools take the Scalextric experience away from toy level, into something that serious slotters can race, and the not so serious can really enjoy.

ElectricImages has the facilities to upgrade your equipment to the Pro tools, so you can really extend and enjoy your slot-car experience without the headaches of the limits imposed upon Scalextric by the toy industry legislators.

See the Pro Upgrade page for details on what these are, and how to buy.